Fiber Optic Network Maintenance

Fiber Optic Network Maintenance

Fiber Optic Network Maintenance

Fiber optics are installed so that regular maintenance is not needed, or recommended. There are many reasons why you do not want to do this.

Most inspection procedures require bringing the network down, unacceptable in almost every instance. Telcos have backup links running alongside operational links and the equipment will switch over to the backup if it senses high errors on the main link. Do you know any premises networks set up like that? Want to bring down an OC192 telco link or gigabit LAN backbone fast? Unplug a fiber optic connector to inspect it with a microscope. See how long it takes the network manager to find you.

It is easy to get dirt into mating adapters or on connectors whenever they are exposed to the air. Fiber technicians are taught to keep connections clean after termination, cover connector ferrules and mating adapters with dust caps and clean the ferrule end whenever it is opened to the air. If dirt is such a big problem, and airborne dirt is the size of the core of singlemode fiber, why risk contaminating operating connectors by exposing them to the air to see if they are dirty? Systems should be designed to protect components from dust in the environment, that’s what cable plant hardware is for.

Mating and unmating may wear the connector interfaces, affecting optical performance. Ferrule endfaces rubbing against the mating connector and the outside of the ferrule scraping materials off the alignment sleeve in the mating adapter, especially with adapters using cheap plastic alignment bushings which are good for only a few mating cycles, can cause higher loss.

Safety can also be an issue. Links operating at gigabit and higher speeds generally use 850 nm VCSELs, which are relatively high power lasers at a wavelength near the high end of human eye sensitivity, still visible to some people. Using a high power microscope, like a 400X, concentrates the light into the eye, increasing the risk of eye damage, especially if you are not able to see this wavelength. Should a link being inspected be “hot,” the consequences could be bad. Anyway, a 400X microscope is overkill – it’s the maximum magnification you would use to inspect singlemode connectors during termination; 100-200X is generally considered the maximum for connector inspection.

The fiber link loss may be different when a link is reassembled after inspection, especially with connectors that have spring loaded ferrules like STs. Inspecting a connection could lead to higher loss than initially measured and potentially affecting data transfer on systems like Gigabit Ethernet and 10G Ethernet where loss margins are very low.

As for testing with an OTDR for maintenance inspection, some telcos do that automatically on spare fibers in outside plant cables that run tens or hundreds of kilometers through desolate regions. An OTDR, unless it is very high resolution, is inappropriate for most premises systems under any circumstances and often causes more problems that it solves.

Finally, if you have a problem with dust in a telecom closet, room or data center, you have a poorly designed facility that should be fixed with proper sealing, filtration and air conditioning.

If you are having an issue with your fiber optic network, please schedule a free site survey.

phone: 440-808-8448

email: info@shoreworx.com

Follow us on Facebook!

About Author: Shannon

Leave a Reply

Your email address will not be published. Required fields are marked *

No Spam! * Time limit is exhausted. Please reload CAPTCHA.